Non-hydrolytic Sol-Gel Routes to Bifunctional Cu-Ta-SiO<sub>2</sub> Catalysts for the Upgrading of Ethanol to Butadiene

Logo poskytovatele

Varování

Publikace nespadá pod Ekonomicko-správní fakultu, ale pod Přírodovědeckou fakultu. Oficiální stránka publikace je na webu muni.cz.
Autoři

DOCHAIN Denis D STÝSKALÍK Aleš VYKOUKAL Vít VIMONT Alexandre TRAVERT Arnaud DEBECKER Damien P

Rok publikování 2023
Druh Článek v odborném periodiku
Časopis / Zdroj CHEMISTRY OF MATERIALS
Fakulta / Pracoviště MU

Přírodovědecká fakulta

Citace
www https://pubs.acs.org/doi/10.1021/acs.chemmater.3c01407
Doi http://dx.doi.org/10.1021/acs.chemmater.3c01407
Klíčová slova HETEROGENEOUS CATALYSTS; CONVERSION; ZEOLITES
Popis The one-step catalytic conversion of bio-based ethanol to 1,3-butadiene is an attractive way to produce this important C4 building block, to be exploited as a sustainable drop-in chemical in the tire and nylon industry. For this catalytic process, bifunctional catalysts combining both redox and acidic properties are required. Here, we leverage non-hydrolytic sol-gel (NHSG) chemistry to prepare tailored Cu-Ta-SiO2 catalysts featuring an open texture, dispersed acidic Ta sites, and small Cu nanoparticles. In the ether route, silicon tetrachloride and tantalum pentachloride undergo polycondensation reactions with diisopropyl ether as the oxygen donor. In the acetamide elimination route, silicon tetraacetate reacts with pentakis(dimethylamido)tantalum(V). In both routes, copper(II) acetylacetonate is added and trapped in a tantalosilicate matrix. Upon calcination, CuO nanoparticles form and the resulting bifunctional material develop a mesoporous texture with specific surface areas in the 650-950 m(2) g(-1) range, pore volumes between 0.75 and 0.90 cm(3) g(-1), and average pore diameters above 3 nm. With the help of NH3-TPD, FTIR, CO- and pyridine-adsorbed FTIR, XRD, XPS, and STEM-EDS, we demonstrate that the catalysts made via the acetamide elimination route show higher performance in the ethanol-to-butadiene reaction, with low selectivity in dehydration byproducts, owing to moderate Lewis acidity, smaller Cu nanoparticles, and higher active site proximity. After optimization of the Ta and Cu loadings, a butadiene productivity as high as 0.38 g(BD) g(cat)(-1) h(-1) is obtained, surpassing state-of-the-art catalysts with similar formulations and tested under similar reaction conditions.
Související projekty:

Používáte starou verzi internetového prohlížeče. Doporučujeme aktualizovat Váš prohlížeč na nejnovější verzi.